I have the HD Suite 2014 and want to design a stairway that goes 1/2 way down to a landing and then changes direction (180 degrees) and then continues to the basement. Possibly putting some winders on the landing.
Thanks,
Ross
Printable View
I have the HD Suite 2014 and want to design a stairway that goes 1/2 way down to a landing and then changes direction (180 degrees) and then continues to the basement. Possibly putting some winders on the landing.
Thanks,
Ross
Look at these Tutorial Videos offered by Home Designer: http://video.homedesigner.chiefarchi...?search=stairs
#'s 2208 & especially #2246
DJP
Yes, I've viewed the stair video 4 or 5 times and when constructing the the 2 section it only gives me 1 riser for 11". I'm thinking that default for the basement walls is less than the 9' that I want/need.
The second section is the landing in a stair like that and is essentially a FLOOR rather than a staircase which is why it is 11" deep, the stairs will / should still give you a riser height of 7" +/- depending on design. you need to build the stairs UP from the basement ,so they will connect properly ....... use a split view with a 3d camera and you can watch what is happening as you do stuff/make changes......
Not sure what you mean about the basement walls and them being 9' ? stairwell is 9'x9' ?
this is a 8'6" staircase ,from a question last month I did .....might help ?
http://hometalk.homedesignersoftware...9738#post79738
Later last night I found my problem, the height of my basement walls was ~48". I looked "floors", basement, and then found that walls were not correct so I changed it to 108" and now it works out.