Trying to add a turbine vent onto the roof of my house in Home Designer Suite 6, does not seem to work either in plan view or 3D, ends up on the ground. Any ideas?
Printable View
Trying to add a turbine vent onto the roof of my house in Home Designer Suite 6, does not seem to work either in plan view or 3D, ends up on the ground. Any ideas?
To get the Turbine Vent to show on the roof you will need to set the height.
This can be done in several ways.
1) Open the item and specify a height in the Floor to Bottom entry.
2) Go into a cross section view and drag it up.
3) Edit it in a 3D view and drag it up.