Printable View
I am using Home Designer Pro 2012.
Currently doing the "before" drawings for a renovation project.
Attached is a picture of the actual structure, and a cross section of the same area. How do I reduce the height of the left and right exterior walls, so that the height of the roof overhang is reduced?
I'm sure there is a simple command, but after spending much time playing with the roof and wall dialogs I can't figure it out.
Thanks in advance.Attachment 14498Attachment 14499
What a matta for u? Why would you think you can change the wall or roof height
in the corresponding Dialog boxes? This just might be my all time peeve about the
software. You can change the wall height in the "Room Specification" dbx. Here's
how I would go about it. First delete your existing roof planes. Then while in plan
view click inside the walls to select the room and hit Ctrl+E to open the Room
Specification dbx. Here you can change the wall heights to whatever you need.
When your walls are set then rebuild the roof planes and you should have it.
Thanks! Also figured out that if you go into the roof dialog box, hit the radio button for "pitch", it allows you to then change the "baseline" measurement above...same result.
Altogether very squidgy ways to alter some measurements that are pretty basic...are the programmers listening?
Jeffery, the "Baseline" value that is stated in Roof Dialog Boxes is not the same thing as "Plate Height" as one might think. the baseline height is a point directly on the surface of the roof plane object along a line that is co-linear with the outer edge of the framing or structural layer of the wall over which the roof plane builds, in other words, a particular point in space.
http://djpdesigns.net/html/roof_dialog.htm
DJP
Quote:
Originally Posted by David J. Potter
Just getting caught up on some of these videos. Great little video David.
Succinct and to the point. This is one of those concepts that you could peck
away at your keyboard until your fingers bleed and never be able to convey
your point. What's that old adage? A video is worth a thousand keystrokes.
Funny thing is that I almost never use the "Baseline" height. I'm usually
interested in the "Fascia Top" height to line up eaves and gutters, and the
"Ridge/Top" height to line up roof planes.
Thanks, David, great video. Really helpful!