confused

[dmmk]

I am totally new to program, and just built a pool area with a small shed..
I wanted to raise the terrain on one side (gentle slope) which I did no problem, I also created flat terrain, (pool area with fence) however at some point my shed is now about 3 feet off the ground, and I cant get it back down, everything else looks good... any suggestions?

[Kilgore Trout]

What version of the program are you using? This might be affected by the auto calculate elevation feature of the terrain. You might try turning this off and then try adjusting your terrain.

Another way to do this is to open up the shed and change the floor height to raise or lower it.

[dmmk]

thanks for the quick response, I'm using version 7.07a, I believe I found the issue, it seems when I changed the elevations the shed tried to follow...
I have a lot to learn
thks again