Results 1 to 10 of 10
Thread: Open triangles in wall ends
Hybrid View
-
08-03-2006, 10:53 AM #1Registered User
- Join Date
- Aug 2006
- Posts
- 5
Yes, that would be helpful. I am using home designer 6.04 and have tried it on several systems. I am using a gateway laptop at the momemt to run the software. Thanks for your patience.
Ernest.
-
08-03-2006, 11:00 AM #2Registered User
- Join Date
- Aug 2006
- Posts
- 5
Yes, I did have the attic walls as knee walls and the space outside the upper room as designated attic. I followed the dormer instructions per the help function. I did notice that I did not seem to have the problem until I used a garage height of 180". I can include the plans as a zip file in case that helps. I may have to make three zip files so that they will be under 100kb each
Thanks,
Ernest
-
08-03-2006, 04:04 PM #3
Check your ceiling heights in the attic rooms. Make the ceiling heights higher in the attic rooms and see what happens.
Dan Park
Customer Support Manager
Chief Architect, Inc
-
08-03-2006, 07:41 PM #4Registered User
- Join Date
- Aug 2006
- Posts
- 5
Thanks for the advice but after raising the ceiling height it still has the same problem. This is driving me crazy. Any other ideas? Any suggestions will be greatly appreciated.
Thanks again,
Ernest
-
08-04-2006, 03:08 AM #5
Zip the plan and post it.
-
08-04-2006, 07:11 AM #6
Without a plan it's going to be hard to diagnose. I suspect it is easy to fix.
Dan Park
Customer Support Manager
Chief Architect, Inc
-
08-04-2006, 07:59 AM #7Registered User
- Join Date
- Aug 2006
- Posts
- 5
I will be happy to post the plan but even zipped it is 160Kb is it ok if I mail it to you or is there another way to get past the 100kb limit? Thank you so much for your help.
Ernest