Results 1 to 2 of 2
Thread: Gable roof not being generated
Threaded View
-
03-10-2010, 11:00 AM #1Registered User
- Join Date
- Mar 2010
- Posts
- 5
Gable roof not being generated
I'm designing a gable on the side of the attached garage over the garage doors and a matching one over the entry to the wrap-around porch. See below.
I sucessfully did it, using line breaks and specifying the wall in-between as a full gable wall. It generated fine initially, as did the gable entry porch.
Then, I changed that wall of the garage, moving the mandoor around to the end (it looked too much like a main entry as shown below) and readjusted the placement of the garage doors. Now, it will no longer generate a gable roof on that wall, though the one over the entry still works fine.
I tried:
(a) deleting the entire wall, and specifying the gable again, using line breaks.
(b) specifying the wall above (shown on the A floor) as a full gable wall, and
(c) deleting that entire wall and defining it all over again...
None of these worked. Any suggestions?
TIA,
KentNew User
Home Designer Suite, v9.0