Results 1 to 15 of 25
Thread: Chase wall for plumbing
Threaded View
-
03-07-2013, 12:24 PM #14
The video has helpful info.
I did fix the issue with the exterior CMU wall corner connection with the interior framed stud/drywall plumbing chase. Creating a "custom" wall and defining each layer as Elovia suggested did the trick.
The issue with the CMU showing up in camera view although the plan showed drywall is fixed, but I did check all the settings etc., you mentioned in your video and the CMU was NOT selected as the finish material. It is fixed now, after using the custom wall type, I pulled a camera view and it shows the drywall.
As you can see in the attached sketches, the interior perpendicular walls of the Elec and HVAC closets don't stop at the chase wall, but continue all the way through and if you notice the screen shot of the camera view now CMU is showing penetrating the drywall finish.
I have tried the help article # 33 "How to Adjust Wall Connections" that didn't change a thing. I have tried checking and unchecking wall "butts" other wall, no luch there. I open the preferences and changed the "snap" dimenstion which did nothing to fix the issue. I've tried a controlled drag pulling the end of the CMU wall back, then slowly draging it back into place and it still snaps all the way through. Any suggestions there? I've attached caputures of the floor plan so you can see the relation ship of each.Last edited by BB boy; 03-07-2013 at 12:28 PM.
BB Boy (Bob E)
Home Designer Pro 10
Home Designer Pro 7.08a
Home Designer Pro 6.04
Home Designer Suite 7
Picture Painter Home & Landscape
Nashville-TN
“ The nicest thing about the future is that it always starts tomorrow”