Problems with different floor elevations?

[Lovamist]

David,

There is no need to be defensive, I understand that the software can only generate what you tell it to do. I just needed a little help on the correct procedure to communicate my ideas to the software.

Anyway, I did eventually figure out the problem: It was not possible to change the height of a room on the second floor by changing the wall heights of a single room on the first floor it - it will always revert to the default settings (or change the entire second floor height) -> instead you must go to the room on the second floor and edit the "ceiling below" height.

The tutorial here: http://www.homedesignersoftware.com/...icle/KB-00140/ spends a lot of time explaining how to define wall heights on the first floor when they cannot change the floor elevations above (you are not extruding like in other 3D software). This was confusing for me.

Thanks for your help and reply!