Reversing Floors

[JoAnn]

If you have the 'edit area' function, you will find it in the top toolbar under edit. I tried it out on a plan, and it worked well.

Open the original plan 1st, then open a new blank plan and vertically tile it beside the older plan.
At the top tool bar under edit, select 'edit area'. Draw a box around floor 2.
Back at the toolbar under edit, select 'copy'.

With the new plan active, go to the toolbar edit/paste/paste hold position (click).

Go back to the older plan and move to floor 1. Surround the floor with the edit box and copy (up at the toolbar copy).

Activate the new plan and select Build/floor/build new floor/make new BLANK plan. Select 'OK'.
NOW go back to the toolbar edit/paste/paste hold position (click).

If the new floor 2 doesn't build correctly, delete the floor and do the paste hold again.

You can also do this with the foundation, and also the terrain elevation lines.