Angle corner cabinets

[BB boy]

bobh-is the attached more like what you are after? If it is you can't build it with suite's cabinet tools. I built this with suite but I used soffits to make the front end closures. In the real world it would have to be custom built by a cabinet shop, or you could probably fake it the way I did with plywood that could be stained to match the rest of the cabinet.

[BB boy]

You are probably trying to do what I have done in the attached. With cabinet tools I made smaller base and wall cabinets. With the Ctrl key down I dragged them into place, and sized them until they looked about right in the elevation. As you can see they look pretty good, but it does not appear that you can build the special shaped top you need. It might be possible with some kind of polyline but I'm not sure. I had a hard enough time building a special top with custom top tool that is in the Pro software. As you can see there is a hole in the top. maybe Allen can help us figure it out, but Suite does not have the covert polyline tool so we can't make it a top, and it does not have the custom counter top tool either.

[bobh]

The top one is the goal. Thanks for the info.

[BB boy]

Your welcome.