Results 1 to 4 of 4
-
04-16-2007, 01:21 PM #1Registered User
- Join Date
- Apr 2007
- Posts
- 3
gabled roof lines on a U-shaped plan
I am trying to get the correct gabled roof lines to generate for my existing house plan, but I am getting a strange 'offset' on either end of the main gabled section. See attached picture. Any ideas for resolution? The desired result is for a gabled roof line over each of the two front 'wings' (Garage and Living Room) that merge into the perpendicular main gabled section at the rear half of the house. Seems like a fairly straight forward design, but I haven't had any luck losing the extra angles where the gabled front sections meet the main gable ridgeline.
Thanks,
atlarge
-
04-16-2007, 01:31 PM #2Registered User
- Join Date
- Apr 2007
- Posts
- 3
Oops!. Home Designer Deluxe Version 7.08
atlarge
-
04-16-2007, 02:22 PM #3
The image is rather small, but if I understood correctly, both the garage and living room should have full gable walls? I think you'll need to use walls breaks to divide up your left and right walls so that only the main house portion has the sides labeled as full gable. Again, that is if I understood correctly. Is this somewhat like what you're trying to achieve?
Last edited by Katalyst777; 04-16-2007 at 02:24 PM.
Kat >^..^<
-
Home Designer Architectural 10
AHD 8
Deluxe 7
-
04-16-2007, 02:32 PM #4Registered User
- Join Date
- Apr 2007
- Posts
- 3
Yup, that looks like what I want. I did have wall breaks on both outside walls with Full-Gabled selected only on the outside wall bordering the main section like you mentioned. At this point, is it just a dimensioning issue and I just need to adjust the location of the breaks in the outside walls to alter the location of the Gable line?