Brick wall alignment

[stali]

I just bought Pro 9.0
I am designing a new house plan for myself. The walls are 6" with brick exterior. The foundation is 10" concrete.
There seems to be a problem aligning the main floor over the foundation. When I use the align above or below tool Pro will align the framing and leave the brick hanging in mid air. If I try to align the walls manually using above or below reference it looks OK in plan view but 3D will build a roof on top of the foundation as well as the main roof. If I delete the unwanted roof there appears to be a 1” ledge at the top of the foundation that isn’t apparent in plan view.
VERY FRISRTATING!
Any suggestions?
Stali

[Allen42ACJ]

There is a foundation wall type with a 4" brick ledge..
Might work better for you..

[stali]

Hey Allen
Thanks man.
It seems to have done the trick.
The reason I didn't use this type of foundation is that I figured "brick ledge" as the step down type used to lower the brickline closer to grade rather than flat.
Thanks again
Stali

[Allen42ACJ]

Hi Stali
You're welcome.
Not sure if you can adjust the height of the ledge or not..Don't work on many brick houses..