Results 1 to 2 of 2
Thread: Confused by Elevation Features
-
10-09-2006, 04:55 PM #1
Registered User
- Join Date
- Oct 2006
- Posts
- 1
Confused by Elevation Features
I cannot seem to get the elevations I put in, match the actual elevations. I am unsure of how to actually put them onto the design correctly. Can anyone give me some ideas? Thanks!
-
10-10-2006, 10:59 PM #2
Registered User
- Join Date
- Sep 2006
- Location
- Farnham, Surrey, England
- Posts
- 73
Hi
I haven’t done much, only 1 project but it seemed to work OK using -Suit 6 and then Pro 7.
I started by converting my elevation data to values relative to the ground floor level of my house. Higher ground being positive, lower negative.
If you go for actual elevations you could end up burying your house unless you set your building pad elevation to the correct value (double click on the terrain boundary to do this).
Reply With Quote
