The shop is 36x50 with an exterior wall height of 17'. Inside the shop will have a mezzanine that will extend 16' ft out from the back wall allowing me to have 8ft ceilings below and on top. I am trying to create the walls for the bathroom to an 8ft height. The program keeps making the walls 17' the same height as the exterior walls. How can I change the inside wall height only.
Thanks in advance
It always helps to know which soft-ware version you're using. Have you tried setting the interior room ceiling height by opening its' dbx and setting it there? how exactly did you create the mezzanine?
Welcome to the Forum!
Important posts/threads you should read:
Welcome New Users
How to get good answers
How to attach pictures
DJP
Sorry That I have not gotten back to your post. I am using Home Designer Suite 6. I am still having the same problem with making interior wall heights different than exterior wall heights.
I ran in to a new problem today . I am tring to build a split level plan.
Question : making one building. How do I make a roof at two different heights. for example a split level home.
In advance Thank you
split level tutorials
http://www.homedesignersoftware.com/...icle/KB-00140/
http://www.homedesignersoftware.com/...icle/KB-00932/
http://www.homedesignersoftware.com/...icle/KB-00901/
mezzanine floor
probably you made the wall 17' high and then tried to make 8ft interior walls right? make the 1st floor 8ft , setup your bathroom, then add another 8ft floor on top, turn on reference display and make an invisible wall along the edge of the bathroom wall/area then you can select the area where there should be no floor and on the room dbx specify it as "open below"
here is a KB Article that might help
http://www.homedesignersoftware.com/...icle/KB-00210/
HD6 is pretty old , so don't know if the above works , it does in HDP 10