Making a closet with different wall height than room

[Dan Park]

Instructions for PRO 6 or 7:

1) draw the room with default ceiling height for the rest of the room.

2) Create a cross section elevation of each wall and edit the height of the wall to the desired height.

3) Place a cabinet soffit in the room and edit it to be the ceiling over the closet. ( a slab could also be used here to fill in the ceiling)

Note that step 2 is a PRO function.

Another method for users of other versions that do not have wall height editing, would be to create two floors. Set the second floor height at the height of the closet and the ceiling at the height between the top of the closet and the ceiling.

Make the area on the second floor that is not where the closet is at as open below. This should give you a reasonable representation of the 3D model.