Results 1 to 2 of 2
Threaded View
-
05-08-2008, 06:46 AM #1Registered User
- Join Date
- May 2008
- Posts
- 1
Add gable roof perpendicular to 2-level gable roof
Hello all! Using Home Designer 6
I have a house that has 2 gable roofs, running along the same plane, but at different levels.
I want to add a room on the back and use a gable roof that is perpendicular to the existing roofs.
Drawing is attached and here is a link to the exported photo:
http://img518.imageshack.us/img518/6312/roofxo0.jpg
here's a better one with the smaller room:
http://img169.imageshack.us/img169/2770/roof2cy0.jpg
The part that is shown with a roof is the existing structure.
The part I want to add the roof to is the flat structure in the front.
I actually don't want it that wide, but want to move the left wall to the right to about the midpoint of the house.
Like I said, I'd like to run the gable perpendicular to the existing gable line so require minimal restructuring. Any thought on how to show it?
I'm not very savy and I had to use an exterior wall inside the plan to get the roof to show the different elevations. I made the ceiling on the left side 150" to gain the height.
Thanks for all input!
Edited to add, everytime I try and add the roof in the meager way I know how, the software rearranges the entire roof into something quite atrocious.Last edited by kirbymurphy; 05-08-2008 at 07:01 AM.